Samsung WD90N6 Series - Page 63

English 63
Troubleshooting
Code Action
DC3
The Add Door lock/unlock is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service
centre.
OC
Water is overowed.
• Restart after spinning.
• If the information code remains on the display, contact a local
Samsung service centre.
LC, LC1
Check the drain hose.
• Make sure the end of the drain hose is placed on the oor.
• Make sure the drain hose is not clogged.
• If the information code remains, contact a customer service
centre.
NOTE
When the washer displays the “LC,LC1” code, the washer do
draining for 3 minutes. During this time, the Power button is
inoperative.
FC
Check the fan motor.
• Power off and power the machine on after 2-3 minutes, and
then try again.
UB
Spinning does not work.
• Make sure laundry is spread out evenly.
• Make sure the washing machine is on a at, stable surface.
• Redistribute the load. If only one item of clothing needs
washing, such as a bathrobe or pair of jeans, the nal spin
result might be unsatisfactory, and an “UB” check message will
be shown in the display.
3C
Check the motor for operation.
• Try restarting the cycle.
• If the information code remains, contact a customer service
centre.
3CP
Check the pulsator motor for operation.
• Try restarting the cycle.
• If the information code remains, contact a customer service
centre.
WD90N644OOW_03924L-00_EN.indd 63 2018/3/1 11:27:06