5-6
5. ASSEMBLY AND DISASSEMBLY
Part Name Descriptive Picture How To Do
Drain Pump
1. Insert the at head screwdriver into the slot on the
top of the Cover Filter and lever it down to separate
it.
2. Unscrew the drain lter by turning it counter
clockwise.
- The water remaining inside could ow out.
So, put an empty bowl on the oor to hold the
water.
Drain Pump
3. Tilt the unit backward and take out the drain pump.
4. Disconnect the incoming water hose and the wire
harness.
(Caution: Check if the unit is plugged out. There is
possibility of electric shock.)
5. Separate the Hose Filter Tub and the Drain Hose.
CHECK POINT
1. Remove the Drain Filter and check if there are foreign substances (coin, buttons, etc) blocking inside - If
so, clear the inside.
2. Check if the wire harness is connected properly - If not, connect it properly.
3. If water leaks, check if the Clamp Hose and the Cap Drain are assembled tightly
- If not, assemble them tightly.
Remove the water remaining inside by turning the Filter counter clockwise.
To Next Page
Loading...
