3-6
3. PRODUCT SPECIFICATIONS
9. Water heater Error function
(1) This function starts working, when the heater works abnormally. (this function begins sensing the heater 2 minutes later,
after the heater operating)
(2) The value of the initial thermistor(A1) is compared with that of the thermistor(A2) in 2 minutes. (Y=A2-A1)
- For 1 minute , if the variance of temperature(Y) increases more than 40˚C, “HE” message is displayed on the panel.
“HE” message means “overheated”
(3) The value of the initial thermistor(A1) is compared with that of the thermistor(A2) in 11 minutes. (Y=A2-A1)
- 10 minutes later, if the variance of temperature(Y) increases less than 2˚C, “6H” message is displayed on the panel.
“6H” message meas “heter do not work”
10. Bubble - detecting function
At the each condition of washing&dehydrating , rinse&dehydrating , hydrating, bubble -detecting function works, this
function works 5times normally, if the function detects bubbles at 6 times , the bubble-detecting function stops and go on
to the next process.
The bubble-detecting function during washing & dehydrating to rinse & dehydrating after 2 times instant dehydrating and
before main dehydrating, if the water level is under 24.50KHZ, Bubble
Detecting function thinks there are bubbles and add the bubbles-removing rinse, needing hours are above hours and
8 Min 40 sec.
The bubble-detecting function during single hydrating process after 2 times instant dehydrating and before main
dehydrating , if the water level is 24.50KHZ below or during main dehydrating, water level data is 24.50KHZ below
Bubble-detecting function thinks there are bubbles and add the bubbles-removing rinse 1 times, needing hours are
above hours and 5 min 50 sec.
y
)
)
To Next Page
Loading...
