No Description Image
1 Tighten the lock-nut up against the base frame.
2
Put a couple of articles of clothing inside and place
paper strips under each leg. And then, put the unit
into Spin Mode as follows.
1. Power ON press SIGNAL and EXTRA RINSE for 3
seconds
2. Press the Delay Start and Silver Care Keys for 3
seconds to enter Quick Spin Test Mode.
As its speed increases, try to pull out the paper
stripes.
Notice! If you find foot-print on the paper, or the
paper is slipped out, lower the regarding leg slightly
and tighten up its lock-nut against the bottom plate.
And, repeat the test until there is no slip-out or foot-
print.
Notice! Partial circle footprint on paper could
indicate a bent leg or frame.
Paper
Washer Vibration Testing
To Next Page
Loading...
