Out of Balance
• When the unbalance time exceeds 15 minutes during the
spin cycle, it executes the untying operation to balance
the load. It will tumble at 50 RPM and add water and
pump out twice, then generate an error (dc) the third
time. This will last about 30 minutes.
• Temperatures under 60° may cause unit not to spin and
generate an error (dc)
– See bulletin on early WF218 for software change on Main PCB
• Installation issues – Not leveled, Not locking the lock
nuts, Bending legs or frame when lifting, Shipping bolts
in place, Springs or struts broken or loose.
• Installed on slippery floor without rubber foot pads.
• Not properly locked on pedestal.
To Next Page
Loading...
