48
Models with Drain Pump Only
Remove the connector and read
the resistance at the terminals on
the Drain Pump: Should be ~14 Ω
1. Unplug the unit.
2. Remove Back Cover.
3. Remove the wire connector.
4. Remove Clamp and Drain Hose.
5. Remove Clamp and Pump Hose.
6. Remove the bolts (3 - 13mm) securing Drain
Pump to Cabinet Bottom.
7. Remove the screw securing Drain Pump to
the support bracket. Twist Drain Pump
clockwise to remove.
** Make sure to put an empty container under
Drain Pump to catch the water still inside
the pump.
To Next Page
Loading...
