Why Samsung WF350AN will not start?
Your Samsung Washer might not start due to several reasons. Ensure the door is firmly closed, the washer is plugged in, and the water source faucets are open. Press the Start/Pause button. Also, check that the Child Lock is not activated. Before the washer starts to fill, it will make clicking noises to check the door lock and do a quick drain. Finally, check the fuse or reset the circuit breaker.
What to do if Samsung WF350AN Washer stops mid-cycle?
If your Samsung washer stops, ensure the power cord is plugged into a live electrical outlet. Check the fuse or reset the circuit breaker. Close the door and press the Start/Pause button. Remember, the washer won't tumble or spin unless the door is closed. The cycle might be pausing or in a soak period. Also, check the screens on the inlet hoses at the faucets for obstructions. Before your washer starts to fill, it will make a series of clicking noises to check the door lock and do a quick drain.
What to do if Samsung Washer does not drain and/or spin?
If your Samsung washer isn't draining or spinning, check the fuse or reset the circuit breaker. Ensure the drain hoses are straight and not kinked. Close the door and press the Start/Pause button. If there is a drain restriction, call for service.
How to fix Samsung WF350AN leaking water?
If your Samsung washer is leaking water, make sure the door is firmly closed and all hose connections are tight. Ensure the end of the drain hose is correctly inserted and secured to the drainage system. Avoid overloading the washer and use high-efficiency detergent to prevent over-sudsing.
What to do if Samsung WF350AN vibrates too much?
If your Samsung washer vibrates or is too noisy, ensure it is set on a level surface and that the shipping bolts have been removed. Make sure the washer is not touching any other object, and that the laundry load is balanced.
How to open locked door on Samsung WF350AN Washer?
To open a locked door on your Samsung washer, press the Start/Pause button to stop the washer. Note that the door will remain locked during the heating portion of the Sanitize cycle, and it may take a few moments for the door lock mechanism to disengage.
Why Samsung WF350AN load is too wet after cycle?
If your laundry load is too wet after the cycle, try using the High or Extra High spin speed. Use high-efficiency detergent to reduce over-sudsing. Very small loads (one or two items) may become unbalanced and not spin out completely.
Why Samsung Washer has no water?
If your Samsung washer has no or not enough water, fully turn on both faucets. Make sure the door is tightly closed and the water inlet hoses are straightened. Disconnect the hoses and clean the screens. Open and close the door, then press the Start/Pause button if the hose filter screens may be clogged.
Why Samsung Washer fills with wrong temperature water?
If your Samsung washer fills with the wrong temperature water, ensure both faucets are fully turned on and that the temperature selection is correct. Verify the hoses are connected to the correct faucets and flush the water lines. Check the water heater, ensuring it's set to deliver a minimum of 120°F (49°C) hot water at the tap, and check its capacity and recovery rate. Disconnect the hoses and clean the screens. As the washer fills, the water temperature may change as the automatic temperature control feature checks incoming water temperature, and you may notice just hot and/or just cold water going through the dispenser when cold or warm wash temperatures are selected.
How to prevent excessive suds in Samsung WF350AN?
To prevent excessive suds in your Samsung washer, use high-efficiency detergent. Reduce the amount of detergent for soft water, small, or lightly soiled loads. Non-HE detergent is not recommended.
To Next Page
General