Samsung WF395BTPA series - Pure Cycle Self-Cleaning

32_ maintaining your washer
PURE CYCLE™
Pure Cycle is a self-cleaning cycle that removes mold that may occur inside the washing machine.
1. Press the Power button.
2. Press the Pure Cycle™ button.
• OncethePureCyclebuttonispressed,theonly
function that can be set is Delay Start.
3. Press the Start/Pause button.
• WhenyoupresstheStart/Pausebutton,PureCycle
begins.
• Using Pure Cycle, you can clean the drum without using a cleansing agent.
• Never use Pure Cycle when laundry is in the washing machine. It may cause damage to the
laundry or a problem with the washing machine.
• Ifyouwanttouseadrumcleansingagent,useonly1/10oftheamountofthedrum
cleansing agent recommended by the cleansing agent manufacturer. (When using a
powder-type cleansing agent , remove the liquid detergent compartment.)
The Pure Cycle Auto Indicator Function
• Ifthe“Pure Cycle” button is lit after a wash, it indicates
that tub (drum) cleaning is required. In this case, remove
the laundry from the washing machine, turn the power on,
and clean the drum by running Pure Cycle.
• IfyoudonotrunPureCycle,the“Pure Cycle” indicator
turns o. However, the “Pure Cycle” indicator will light
again after two washes. Not running Pure Cycle at this
point will not cause a problem with the washing machine.
• AlthoughthePureCycleAutoIndicatorappearsoncea
month or so, the frequency may dier depending on the
number of times the washing machine is used.
maintaining your washer
CAUTION
WF395BTPA-03145B-06_EN.indd 32 2014-2-24 11:52:46