Samsung WF428AAW - Page 26

26_ Troubleshooting
ERROR IMAGE MEANING SOLUTION
Problem with control. Call for service.
A fault is detected in the water level
sensor.
Call for service
Jammed Key. Call for service
• Motor speed sensor problem.
• High current detected.
• Motor not running properly.
Restart the cycle pressing the Start/
Pause Button. If the code reappears, call
for service.
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
SilverCare™ control problem Restart the cycle.
If the code reappears, call for service.
Test Mode
Test Mode
Test Mode
System error. Call for service.
Too many suds are detected during the
washing session.
The unit is put on hold until the suds are
reduced. Then, the unit will go back to
the operation.
When it finishes washing, End and SUdS
codes will blink in turn.
To prevent it, cut down on detergents.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
troubleshooting
WF448AAW-02535B-11_EN.indd Sec7:26WF448AAW-02535B-11_EN.indd Sec7:26 2011-01-13 ¿ÀÀü 10:27:192011-01-13 ¿ÀÀü 10:27:19