ERROR IMAGE MEANING SOLUTION
Problem with control. Call for service.
A fault is detected in the water level
sensor.
Call for service
Jammed Key. Call for service
• Motor not running properly.
• Motor speed sensor problem.
• High current detected.
Restart the cycle pressing the Start/
Pause Button. If the code reappears,
call for service.
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
SilverCare™ control problem Restart the cycle.
If the code reappears, call for service.
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
To prevent it, cut down on detergents.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
troubleshooting
To Next Page
Loading...
