Samsung WF5000HA-PJT - Page 17

Removal and Reassembly _ 15
Part Figure Description
WATER LEVEL
SENSOR
(The Hook type)
The Hook type water level sensor
Noiselter
Watervalve
Sensor pressure
► Disassembly
1. SeparatetheTopAssy-Plate.
1. Toremovethewaterleversensor,pushitslowly
inthedirectionofthearrowshowninthegureon
theleft.
 Sincethisdisassemblymethodusesthe
elasticityofthewaterlevelsensorhook,
imposingtoostrongaforcemaydamageit.
A
2. Whileaforceisimposedonthewaterleversensor
asdirectedinstep1,pullthehook
A
inthe
directionofthearrowuntilitisremovedfromthe
bracketspring.
B
3. Imposeaforceslowlyinthedirectionofthearrow
designatedinthegureontheleftuntilthehook
B
isremoved.Thenremovethewaterlevelsensor.
► Assembly
1. Connectthepressurehosetothebodyofthe
waterlevelsensorandlockitusingtheclamp.
 Whenconnectingthewaterlevelsensortothe
set,makesuretoconnectitafterdrainingwater
byoperatingthespincycle.
2. Toreattachthewaterlevelsensor,insertthehook
backintothesquareholeuntilyouheara“click”.