Samsung WF806U4SA series - Page 25

Disassembly and Reassembly _ 23
Part Figure Description
Heater
1. SeparatetheBackCover.
2. SeparatetheConnectionHousing(3).
3. Removethewirevinyl.(1)
4. Separate Connection Housing.
5. Removethennutholdingtheheaterin
placeandthenseparateouttheheater.
 UseboxDrivers(Socketsize:10mm)
6. RemovetheHeaterfromtheTub.
Caution
 Makesuretoinsert
theHeaterintothe
correct position of
thebracketinside
theTubwhen
reassemblingit.
Otherwise,thereisa
dangerofare.
 MakesuretopushtheTubinwardsuntilthe
packingpartcomesintotheTubcompletely
whenreassembling.
Fastentheholdingnutwithaforceof5Kgf/cm2.
Ifthenutisnotfastenedproperly,thereisa
dangerofwaterleaking.