36
Cleaning the debris filter
We recommend cleaning the debris filter at least 5 or 6 times a year, or when the "5E" error message is
displayed. If foreign substances accumulate at the debris filter, the performance of the Eco Bubble function
will be reduced.
CAUTION: Before cleaning the debris filter, make sure to unplug the washing machine from the
electrical outlet.
CAUTION: Do not disassemble the debris filter while the machine is running as hot water may flow
out.
1. Open the lter cover (A) by pressing down and pulling its handle.
2. Remove the remaining water (refer to the "Draining the washing
machine in an emergency" section on page 35.)
If you separate the filter without draining the remaining
water, the remaining water may trickle out.
3. Unscrew the debris lter cap (B) by turning it to the left.
4. Wash any dirt or other material from the debris filter. Make sure the
drain pump propeller behind the debris filter is not blocked.
5. Replace the debris filter cap.
6. Close the filter cover.
Make sure to replace the debris filter after cleaning it. If the debris filter is not reinserted into the
machine, your washing machine may malfunction or water may leak.
Tighten the debris filter firmly after cleaning it. Failing to do so may result in a malfunction or water
leak.
Cleaning the exterior
1. Wipe the washing machine surfaces, including the control panel, with a soft cloth using a non abrasive
household detergent.
2. Use a soft cloth to dry the surfaces.
CAUTION: Do not pour water onto the washing machine.
F700E_WF80F7E-03248A-01_EN.indd 36 2013-03-08 �� 3:05:25
To Next Page
Loading...
