Samsung WF856UHSAGD/SA - Page 26

24 _ Removal and Reassembly
No. Part name Description Figure
13
BUBBLE
PUMP AND
DRAIN PUMP
6.Release the clamper
hose which con-
nected pump and hose
drain,thenseperateit.
7.Disconnect the terminal
ofwires.
8.Remove 3 screws as
photograph, then sep-
erate pump drain and
replaceit.
※Check Points for Troubleshooting
1.Separate the Drain Filter and check if any alien substances are
insidethepump(e.g.coins,buttons..,etc.)→Removetheseif
found.
2.Checkifthewiredrivingthepumpishascomeloose→Take
therelevantcountermeasureifnecessary.
3.Whenwaterleaks,checktheassemblystatusoftheClamp
Hose,andCapDrain→Taketherelevantcountermeasureif
necessary.
Turntheltercounterclockwisetoremovetheremainingwater.