SAMWONTECH
1st Edition of TEMI2000_Series IM : Dec. 15. 2008 Page 26 / 58
█ Bit Map status information D-Register
D-Reg. Symbol Descriptions
D0010 NOWSTS Current operation status information.
D0011 IS.STS INNER signal generating status information.
D0012 TS.STS TIME signal generating status information.
D0013 ALM.STS ALARM signal generating status information.
D0014 ONOFF.STS ON/OFF signal generating status information.
D0015 DOCTR.STS Other DO signal generating status information.
D0016 CTR.STS Displayed DO signal status information on 2
nd
Oper screen
D0017 DO.STS1
D0018 DO.STS2
Actual generating Do signal status through I/O board
D0010 DI.DATA DI Error outbreak status information.
D0020 ADERR.STS Error status out of control range
█ Common process information D-Register for both PROG / FIX
D-Reg. Symbol Descriptions
D0001 TEMP.NPV Current temperature PV
D0002 TEMP.NSP Current temperature SP
D0003 WET.NPV Current WET temperature PV
D0004 WET.NSP Current WET temperature SP
D0005 HUMI.NPV Current relative humidity PV
D0006 HUMI.NSP Current humidity SP
D0007 TEMP.MVOUT Current temperature percentage control output (MV)
D0008 HUMI.MVOUT Current humidity percentage control output (MV)
D0009 C.PIDNO Currently running PID number
D0024 RUN.TIME_H Process time (Hour)
D0025 RUN.TIME_M Process time (Minute)
D0026 RUN.TIME_S Process time (Second)
█ PROGRAM operation process information D-Register
D-Reg. Symbol Descriptions
D0027 RUN.PTNO Currently running program pattern number
D0028 RUN.SEGNO Currently running program segment number
D0029 NOW.PT.RPT Count of current Repeat operation at running pattern
D0030 TOTAL.PT.RPT Total Programmed Count of Repeat op. at running pattern
D0031 NOW.SEG.RPT Count of current Repeat operation at running segment
D0032 TOTAL.SEG.RPT Total Programmed Count of Repeat op. at running segment
D0033 NOW.SEGTIME_H Process time(High) of currently running segment
D0034 NOW.SEGTIME_L Process time(Low) of currently running segment
D0035 TOTAL.SEGTIME_H Programmed total time(High) of currently running segment
D0036 TOTAL.SEGTIME_L Programmed total time(Low) of currently running SEG
D0039 PREV.TEMP.TSP Temperature Target Set Point of the preceding segment
D0040 NOW.TEMP.TSP Temperature Target Set Point of the current segment
D0041 PREV.HUMI.TSP Humidity Target Set Point of the preceding segment
D0042 NOW.HUMI.TSP Humidity Target Set Point of the current segment
D0050 USED PATTERN Total number of programmed pattern
D0051 USED SEGMENT Total number of programmed segment
To Next Page
Loading...
