Samwontech TEMP2500 Communications Manual

SAMWONTECH
1th Edition of TEMP2000_Series IM : Dec. 15. 2008 Page 9 / 63
5.2 Type of Communication Command
Two types of commands are provided on TEMP2500. One is general READ/WRITE command to read and write
information on D-Register, and the other is Reference command to read self-information of TEMP2500.
▣ Reference Command
Command Description
AMI Displays model name and Version-Revision of TEMP2500
▣ Read/Write Command
Command Description
RSD Read data in consecutive D-Register in sequence (Read)
RRD Read data in arbitrary single D-Register (Read)
WSD Write data in consecutive D-Register in sequence (Write)
WRD Write data in arbitrary single D-Register (Write)
STD Register arbitrary single address to monitor (D-Register Monitoring Set)
CLD Read data in address registered by STD command (D-Register Monitoring Call)
☞ Each Command can read or write up to 64 D-Register and all of the SED/CLD data will be reset by power OFF,
so the data should be registered again.

Samwontech TEMP2500 Specifications

General

Brand	Samwontech
Model	TEMP2500
Category	Controller
Language	English