SAMWONTECH
1th Edition of TEMP2000_Series IM : Dec. 15. 2008 Page 39 / 63
7.13 OUTPUT Group
This INPUT group is used for setting parameter D-Register for control output and retransmission.
█ Control output and retransmission setting D-Register
D-Reg. Symbol Descriptions
D1301 SSR1.OUT SSR1 Control OUTPUT type.
D1302 SSR2.OUT SSR2 Control OUTPUT type.
D1303 SCR1.OUT SCR1 Control OUTPUT type.
D1304 SCR2.OUT SCR2 Control OUTPUT type.
D1309 DIR Select the direction of behavior.(0:REV, 1:FWD)
D1311 ARW ARW(Anti Reset Wind-up) sets the value of prevention
D1313 UPOPR Change the setting up of the control output.
D1314 DNOPR Change the setting of control output is falling.
D1317 CT Sets the output cycle.
D1319 PO Output is in an emergency setting.
D1321 ATG Auto-Tuning GAIN value for Manual PID.
D1325 RETT Target object of transmission (0:PV, 1:SP, 2:MV)
D1327 RETH Range High of transmission
D1328 RETL Range Low of transmission
To Next Page
Loading...
