SAMWONTECH
1th Edition of TEMP2000_Series IM : Dec. 15. 2008 Page 38 / 63
7.12 INPUT Group
This INPUT group is used for setting parameter D-Register for sensor and its bias.
█ INPUT setting D-Register
D-Reg. Symbol Descriptions
D1201 SENGP Select the sensor group. (0:T/C, 1:RTD, 2:DCV)
D1202 SENTP Sets the type of sensor.
D1203 UNIT Sets the sensor unit.
D1204 DP Set-point position.
D1205 TCSL T/C select show (0:T/C, 1:T/C+RJC, 2:RJC)
D1206 SOPN.SEL Sensors-open, pv select the direction. (0:UNSET, 1:UP, 2:DOWN)
D1207 INRH Sets the High limit range of use.
D1208 INRL Sets the Low limit range of use.
D1209 BIAS Sets the previous range revision value.
D1210 INFL
Removes noise when measuring input includes noise of high
frequency.
D1212 INSH Scale sets the High limit.
D1213 INSL Scale sets the Low limit.
D1231~D1238 BP1.DDV~BP8.DDV Sets revision temperature at each standard temperature.
D1239~D1246 BP1.DPV~BP8.DPV Sets each standard temperature.
To Next Page
Loading...
