Need help?Do you have a question about the San Jamar SAF-T-ICE and is the answer not in the manual?
General| Product Type | Ice Scoop |
|---|---|
| Type | Ice Scoop |
| NSF Listed | Yes |
| Dishwasher Safe | Yes |
| FDA Compliant | Yes |
| Scoop Material | Polycarbonate |
| Length | 17.5 inches |
| Width | 12.5 inches |
| Handle Type | Ergonomic Handle |
Leave button on first notch to dispense 24 oz. of ice.
Depress button on top of handle and slide forward to 2nd notch to dispense 16 oz of ice.
Depress button on top of handle and slide forward to 3rd notch to dispense 8 oz. of ice.
Select wire hanger, position under mounting bracket, slide upward. Position Guardian into bracket locking rails.
Bend the outside end of the wire hangers as needed to fit the bin lip and set into place.
Mount Guardian System using wire hangers for inside bin placement.
Secure Guardian System using suction cups onto mounting bracket.
For best results, mount using wire hangers and suction cups together.
Secure bracket to surface using appropriate hardware for permanent mounting.
Drain cap allows excess water to drain or be retained, preventing floor hazards.
Remove Guardian unit, clean and sanitize scoop and Guardian unit using standard procedures.
Squeeze handle tabs to begin disassembly of the scoop's button mechanism.
Push the button out of the handle assembly for removal.
Pull the plate forward to detach the pusher from the scoop.
List of available replacement parts for the Saf-T-Ice Scoop and Guardian System.
To Next Page
