S&C Vista SD - Visual Component Identification

10 S&C Instruction Sheet 695-545
Operation
Figure 6. Pull the operating handle guide ring knob forward to move the guide ring into the active (down) position (a and b);
insert the handle through the guide ring and attach it to the shaft of the operating mechanism (c) and (d).
Figure 5. Storage location of the manual operating handle.
STEP 5. Retrieve the manual operating handle from its
storage location at the top-left side of the
switchgear assembly. See Figure 5.
STEP 6. Pull the knob forward at the top of the enclosure
entryway to move the manual operating guide
ring to the active (down) position. See Figure6(a)
and 6(b). Insert the manual operating handle
through the guide ring; attach the handle to the
shaft of the operating mechanism. See Figure
6(c), and 6(d).
Manual operating handle
(b)
(c) (d)
(a)