SandenVendo V21 621 - Page 81

V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230298
the discount setting mode as listed below. Pressing selection button three will save the settings
and return to the “
diSC” mode.
DISCOUNT SETTING OPTIONS
CtL1
Turns the discount setting On/Off
SdSC
Set selection buttons – (y) assigned/(n) not assigned
Strt
Set time for discounting to begin
dAY
Set days to discount
Hour
Set time for discounting to begin
StoP
Set time for discounting to stop
dAY
Set days for discounting to stop
Hour
Set time to start (24 hours)
LESS
Set discount amount
SET-UP AND CODE DESCRIPTION (CONTINUED)
OUEr Over-Ride Mode (Units equipped with optional key switch)
This feature is used to allow you to manually over-ride (via a key switch) pricing, blocking, low
energy operation and discounting. If selection button two is pressed at the “
OUEr” prompt, the
controller will enter the Over-Ride Mode. Upon entry into this program the display will show
“
FrEn”. If selection button one is pressed it will cycle through the override setting options as
listed below. Pressing selection button three will save the currently displayed setting and return
the operator to the “
OUEr” prompt.
OVER-RIDE SETTING OPTIONS
FrEn
Enable/Disable free vend (Edit mode Y/N)
bLCn
Selection blocking over-ride
Litn
Lighting over-ride
rFGn
Refrigeration over-ride
dScn
Discounting over-ride
FrEn Over-Ride Free Vend
V21 12.1 Programming Trade | P3-15