SARGENT AND GREENLEAF® (S&G®)
MANUAL LOCK
Model 6730
• Left-Right-Left Dialing Sequence; One Handed Operation
• Key Locking Day-Lock Option Allowing Dial Lock Position Open or Closed
• Time Tested Mechanical Security
• Internal Relocker to Protect Against Dial and Spindle Punching Attacks
• All Metal Combination Wheels
• Dual Locking Arm Design Prevents Combination Drift Over Time
• One Million Possible Combinations
OPERATING INSTRUCTIONS
Opening Safe for the First Time
S&G® Manual Lock combination is set leaving the
factory with the dial locked in place by the
Day-Lock. The safe will open by simply rotating the
hub or hand wheel clockwise and pulling the safe door
open. If the hub seems stiff, try inserting a solid
round wooden stick into one of the handle holes and
turning the hub clockwise to open.
1. There is an envelope inside the safe with a set of
keys. Unlock the Day-Lock by inserting the key into
the Day-Lock keyhole and turning the key
clockwise until it stops.
2. Remove the key. Now the dial is operational.
Verifying the Combination
The unique combination of the manual lock can be found on the envelope that
contained the Owner’s Manual and Day-Lock keys. With the safe door open,
extend the locking bolts by turning the handle or hand wheel counter-clockwise.
Verify the combination multiple times (by following the directions below) before
using the safe.
Operating the Dial on the Manual Lock
The manual lock requires accurate alignment of each two-digit number with the
Index Mark (each two-digit number of the combination is separated by dashes).
Avoid rotating past any number, even slightly, as the entire combination must be
re-dialed if there are any errors.
To Next Page
Need help?
General