90º Spigot rotation
3.3. ELECTRICAL CONNECTION
1
Remove the 3 screws TORX T40
(with hexagonal head 10 mm) in
the cover.
2
Open equipment
3
Turn the spigots
4
Close and do not
forget to screw the lid
back into position
Power supply: 230V – 50Hz
Maximum current: 0.35 A
Electrical protection: 2 A
Maximum power: 47W
Depending on installation pressure drop, to adjust
working pressure via potentiometer (80-180Pa)
Accessory for duct of Ø100: place the accessory in the spigot and fix it with the clamp.
4. MAINTENANCE
Attention: Before any handling, switch off the power supply to the device.
Every 6 months: With a damp cloth clean both the inlets from the rooms and the extraction grilles from the wet rooms.
Every 2 years: Open the unit and remove the dust from the inside with a dry brush.
5.WASTE MANAGEMENT
Product according to RAEE.
EU regulations and our commitment to future generations oblige us t
o recycle used materials; please remember t
o
dispose of all superfluous
packaging materials at the appropriate recycling points, and to drop off obsolete equipment at the nearest waste management point.
For any questions regarding S&P products, contact one of our After Sales offices (Spain only) or your dealer (rest of world). To find your nearest S&P
dealer, visit our website at www.solerpalau.com.
3 * TORX T40
(with hexagonal head 10 mm)
Pressure adjustment
potentiometer
Ref. 9023064700
To Previous Page
Loading...
Need help?
General