Need help?Do you have a question about the S&P SLIM Series and is the answer not in the manual?
General| Brand | S&P |
|---|---|
| Model | SLIM Series |
| Category | Heating System |
| Language | English |
Procedure for removing filters from the bottom of the unit.
Wiring instructions for connecting the external touch display.
Factory wiring diagrams for different SLIM models and configurations.
Lists all terminal blocks and relay connections for inputs and outputs.
Wiring examples for external components and modes.
Selecting and configuring ventilation modes (CAV, VAV, COP).
Detailed guide for CAV mode operation and settings.
Guide for VAV mode, including sensor input and airflow range.
Guide for COP mode, focusing on pressure control.
Steps to set up time programs for fan speeds and holidays.
Reconfiguring the SLIM controller for external cooling/heating modules.
Step-by-step procedure for installing an electrical preheater.
Reconfiguring the SLIM controller after installing an electrical preheater.
Connecting to BMS using the Modbus protocol.
Configuring Modbus RTU communication over RS485.
Configuring Modbus TCP/IP communication.
Connecting to BMS using the BACnet protocol.
Configuring BACnet MS/TP communication over RS485.
Configuring BACnet IP communication.
Key parameters for BMS integration.
Table of common anomalies, their causes, and solutions.
To Next Page
