How to fix high pressure on SandPro Swimming Pool Filter?
If the pressure gauge on your SandPro Swimming Pool Filter reads over 15 psi, it's likely due to a dirty filter bed. To resolve this, backwash the filter.
What to do if SandPro 4517 pump does not run?
If your SandPro Swimming Pool Filter pump isn't running, first, ensure it's properly plugged into a working socket and that the power cord is in good condition. Also, check if the GFCI or main circuit breaker has tripped; if so, switch it back on. However, if the breaker trips again immediately, it indicates a defect in the pump or its controls, requiring replacement of the pump/motor assembly.
Why is there sand in my pool from SandPro 4517?
If you find sand in your pool after using a SandPro Swimming Pool Filter, there could be several reasons. If the sand is newly replaced, undersized grains might still be present; backwash several times until the backwash water runs clear. Another cause could be sand in the central valve from backwashing; purge into the drainpipe for 30 seconds. Also, check if the separation wall inside the filter is improperly installed or if the filter's bottom strainer is damaged, requiring replacement.
How to remove air from SandPro 4517 system?
If you notice air in your SandPro Swimming Pool Filter system, it could be because the water level is low or the system was recently opened for service. While the pump is running, carefully loosen (but do not remove) one of the screw-on transparent covers on the filter tank to allow any trapped air to escape. Once all the air has escaped, tighten the cover securely.
What to do if SandPro 4517 is leaking?
If your SandPro Swimming Pool Filter is leaking, a possible cause is a faulty seal. Inspect the seal and replace it if necessary. Another reason might be that the clamp isn't tight enough. Tighten the clamp, but be careful not to overtighten it; the maximum torque should be 35 in/lb.
Why is there air in the pump of my SandPro Swimming Pool Filter?
If you notice air in the pump of your SandPro Swimming Pool Filter, it might be due to a poor seal on the intake side of the pump. Try tightening the hose clamps and connection fittings to improve the seal.
What to do if water flows into the drainpipe of SandPro 4517 Swimming Pool Filter?
If water flows into the drainpipe of your SandPro Swimming Pool Filter, it is likely due to dirt around the seal of the multi-port valve. To fix this, unscrew the multi-port valve from the tank cover and clean the seal.
Details GFCI outlet requirements, avoiding extension cords, and handling cords safely.
Step-by-step guide to assemble the water pump onto the base plate and connect hoses.
Instructions for installing the drain valve, manifold, and placing the tank onto the base plate.
Details installing the main tank seal, clamp ring, threaded connectors, and pressure gauge.
Describes the functions of each setting on the 7-position multi-port valve for optimal operation.
Advises unplugging the pump before changing valve positions to prevent damage.
Guidance on initial setup after assembly, focusing on cleaning new sand before filtering.
Detailed procedure for backwashing the filter to remove debris and resettle the sand bed.
General| Flow Rate | 45 GPM |
|---|---|
| Turnover (8 Hours) | 21, 600 Gallons |
| Max Working Pressure | 50 PSI |
| Filter Type | Sand |
| Media Capacity | 150 lbs |
| Filter Area | 1.7 sq. ft. |
| Pipe Size | 1.5 inches |
| Tank Diameter | 17 inches |
| Inlet/Outlet Size | 1.5 inches |
To Next Page