Sandstrom SDW60W15N - Troubleshooting; Technical Problems

46
GB
Hints and Tips
Technical Problems
Technical Problems
Problem Possible Causes Remedy
The dishwasher does
not start.
The door is not properly closed. Close the door firmly.
The unit is not connected to
the mains socket.
Connect the mains plug to the
mains socket.
The unit is not switched on. Press the
On/Off button and
select a programme.
Error code “E1”
displayed.
Long inlet time. tFaucet is not open.
tWater intake is restricted.
tWater pressure is too low.
Error code “E4”
displayed.
tOverflow.
tLeakage in the dishwasher.
tDisconnect from the mains socket.
tCall a qualified service agent.
Error code “E8”
displayed.
Failure of orientation of
distributary valve.
tOpen circuit or break of distributary
valve.
Error code “EC”
displayed.
tFault of PCB data transmission.
tPCB failure.
tCall a qualified service agent.
The drain pump is
not working properly.
The anti-flooding system has
operated.
tDisconnect from the mains socket.
tDisconnect the water inlet.
tCall a qualified technician.
General Problems
Problem Possible Causes Remedy
Detergent residue is left in
the dispenser at the end of
the programme.
The detergent dispenser was
still damp when detergent
was added.
Make sure the dispenser is dry
before adding detergent.
The detergent dispenser lid
cannot be closed properly.
Clogged detergent residue is
blocking the catch.
Clean the catch.
t Repairs should only be carried out by a qualified technician in strict accordance with current local and
national safety regulations. Unauthorised or incorrect repairs could cause personal injury or damage to
the unit.
t Before calling for service, please refer to the section Hints and Tips to solve some general problems by
yourself.
SDW60W15N_IB_5L_Final150521.indb 46 21/5/15 12:28 pm