Sangean DDR-75BT - Page 13

12
6. Press the Tuning Up or Down buttons on the panel (Alternatively, the Folder Up or Down
buttons on the remote control handset) to choose an auto-update option for the clock. This
can be updated from DAB or FM radio, from the Network, or not updated. The default is to
auto update from the network. You will rst need to select the correct time zone and daylight
savings setting, see steps 7 and 8. If you choose “No update” you will need to set the clock
manually later (see the section of ‘Manually setting the clock’). Press the Select button to
conrm your choice.
7. Press the Tuning Up or Down buttons on the panel (Folder Up or Down buttons on the
remote control handset) to highlight the time zone which is applicable to your location. Press
the Select button to enter the setting.
8. You will then need to set the Daylight Savings option according to your location (Daylight
Savings is also known as Summer/Winter time). Press the Folder Up or Down buttons on the
remote control handset to highlight “YES” to turn on daylight savings if required or ‘NO’ if you
do not wish to use daylight savings then press the Select button to conrm the setting.
9. The display will then show a list of WiFi regional options for the network set up. Press the
TuningUp or Down buttons on the panel (Alternatively, the Folder Up or Down buttons on
the remote control handset) to highlight the required region and then press the Select button
to select it. Do this even if planning to use the wired Ethernet connection. Your radio will
then scan for available WiFi networks. If using WiFi we recommend that the WiFi antenna is
positioned vertically.
10. The radio will enter the Network Settings Wizard and will display ‘Scanning…’. After a short
while the display will show a list of the available WiFi networks. If you are intending to use the
WiFi connection, go to step 11.
To use the Ethernet connection to your router (with automatic conguration). Press the Folder
Up or Down buttons on the remote control handset to point to the “[Wired]’ menu item. Press
the Select button and the radio will attempt to connect.
Auto update
Update from DAB
Update from FM
Update from Network
No update
*
Set timezone
UTC + 00:00: Dublin, Lond *
UTC + 00:30:
UTC + 01:00: Madrid, Am
UTC + 01:30:
UTC + 02:00: Athens, Cair
UTC + 02:30:
Wlan region
Europe
Australia
SSID
[WPS]Smith
Jones
Paul’s network
[Rescan]
[Wired]
[Manual config]
Network wizard
Scanning... /
Network settings
Waiting for
Ethernet
Please wait
Daylight savings
Daylight savings