Sangean DDR-75BT - Manual Network Configuration

17
GB
Manual network conguration
If you do not wish to use DHCP for automatic network configuration, or if your network is
congured with a hidden SSID, then you will need to enter some network settings manually. The
typical user will not need to use manual network conguration. The facility is provided to allow
the product is to be used with networks where the conguration of devices is not managed by the
router, or where customized settings may be required. In such cases it is assumed that the user
already has sufficient knowledge to understand the terms and settings used for this purpose.
IPv4 address schemes are used.
1. From the radio Network settings menu, select ‘Manual settings’. You must then choose whether
to connect using ‘Wired’ or ‘Wireless’ connections. If you choose ‘Wireless’ there are as many
as nine settings screens, shown by the ‘1 of 9’ progress marker in the top right corner of the
display. If you choose ‘Wired’ there are ve screens and the progress marker will reect this,
although the steps to set up the network parameters are basically the same.
2. The subsequent menus allow conguration of the following parameters:
� DHCP - On or Off
� IP address - e.g. 129.168.1.25
� Subnet mask - e.g. 255.255.255.0
� Gateway address - e.g. 129.168.1.1
� DNS address (primary and secondary addresses)
� SSID - needed for WiFi connections if the SSID is not broadcast
� WEP/WPA/WPA2 key and settings
� When entering numbers, the SSID or the WiFi pass key, the three controls on the right-hand
side of the screen have special functions. You can quickly access these by pressing the Info
button and then use the Folder Up or Down and the Select buttons as needed:
� select ' ' to erase a character just entered (long press to clear); Info again to continue
� select ' ' when the complete encryption key has been entered
� select ' ' to cancel and go back to the TKIP/AES options screen
3. Upon completion of the settings the radio should connect to the network. If the connection is made
successfully, the radio will return to the Network Settings menu. If the unit cannot connect, then it
will display a 'Failed to connect' message. You will then need to identify which setting may need to
be changed, or whether some other network issue is responsible. Once connected, the network
settings are saved. They are retained in memory while the radio is disconnected from the mains.
Connection type 1/9
Wired
Wireless
>
>
IP address
Subnet mask
192
IP settings
3/9
168 1 25
255
255 255 0
SSID: 6/9
mynetwork
,
BKSP
OK
CANCEL
Network settings
Network wizard
PBC Wlan setup
View settings
Wlan region
Manual settings
NetRemote PIN Setup
>
Network settings
Network wizard
PBC Wlan setup
View settings
Wlan region
Manual settings
NetRemote PIN Setup
>
Please wait
Connecting... /
Network settings