9
Setting tuning step
Tuning step on some countries are different from where you
purchase the radio.
While radio is switched off, long press the Band button for approx.
7 seconds until display flashes current FM tuning step 50 ( kHz ).
Rotate the Tuning Control, you may adjust to 100 ( kHz ).
Press Band button again to confirm the setting.
After FM tuning step is reset, pressing Band button again,
display will show AM and flash 9 ( kHz ). Rotate the Tuning Control,
you may adjust to 10 ( kHz ). Press band button again to confirm
the setting.
Clear the preset stations
Whenever is necessary, you can clear all the preset stations.
When radio is off, press Preset button 1 and Band button at the
same time for more than 2 seconds to clear all the preset stations.
Radio will be reset to original factory set status.
To Next Page
Loading...
