What to do if there is a Reset Button Error on Sankosha Finishers?
If the Reset Button on your Sankosha Finishers remains ON for more than 15 seconds, release the button and remove any obstructions. If the 'E20' error appears even when the button is not pressed, it indicates a button problem. Check if the switch is broken or if the wire connection is loose or disconnected.
What causes Rotation Start Overtime Error in Sankosha DF-100E-V3?
If the red light of the sensor does not turn on when you put a magnet over the rotation middle sensor, the sensor is in error. Check if the sensor is broken, or the wire connection is loose or disconnected. Also, check the air pressure, ensuring the Body Rotation Cylinder Pressure is at 0.3MPa.
What causes Rotation End Overtime Error in Sankosha DF-100E-V3 Finishers?
If the red light does not turn on when you put a magnet over the rotation end sensor, it is a sensor problem. Check if the sensor is broken, or the wire connection is loose or disconnected. If the red light does light, it is considered the wrong position of the sensor. Please loosen the band of it, and find the lighting zone. Please place center of lighting zone and fix it. Check air pressure, ensuring the Body Rotation Cylinder Pressure is at 0.3MPa.
To Next Page
General