Install the Drip Tray and Pitcher
Clip in the included drip tray and place the pitcher on top.
Plug In
Connect your Sans purifier to an electrical outlet. With the
pitcher in place, filtration will begin automatically. Allow a
moment for the internal tank to fill.
Run 4 Filtration Cycles
To prepare the new filters in your purifier, run through four
cycles of filling the tank and allowing it to dispense into the
pitcher. Discard the water in the pitcher each time.
Fill the Tank
Wash both the tank and pitcher with soap and water. Fill the
tap water tank with cold (never hot) water until the water level
reaches the Max line. Return the tank to the purifier.
To Next Page
Loading...
