Need help?Do you have a question about the Sansui AU-999 and is the answer not in the manual?
General| Power Output | 50 watts per channel into 8Ω (stereo) |
|---|---|
| Total Harmonic Distortion | 0.1% |
| Damping Factor | 50 |
| Speaker Load Impedance | 4Ω to 16Ω |
| Input Sensitivity | 2.5mV (MM) |
| Channel Separation | 50dB |
| Signal to Noise Ratio | 70dB (MM), 90dB (line) |
Describes the power indicator light.
Manages speaker system connections.
Controls power to the unit and outlets.
For private listening with headphones.
Checks speaker output balance.
Adjusts overall sound level.
Selects audio input sources.
Controls stereo/mono playback modes.
Compensates for channel imbalances.
Adjusts bass, midrange, and treble frequencies.
Sets specific frequencies for tone control adjustments.
Reduces unwanted low or high-frequency noise.
Selects tape deck for audio monitoring.
Attenuates signal for noise reduction purposes.
Facilitates copying audio tapes between decks.
Details how to connect loudspeakers to the amplifier.
Explains connecting and playing turntables.
Instructions for connecting and listening to radio broadcasts.
How to connect and operate microphones.
How to connect tape recorders.
How to record audio to tape.
How to play back recorded tapes.
How to monitor tape playback.
How to copy tapes.
Explains the advantages and function of the crossover system.
Details how to set up the electronic crossover system.
Covers connectors, wiring, and placement.
Adjusting input signal levels.
Resolving hum, howling issues.
How to check speaker phasing.
How to ground the system.
Details on quick-acting and power fuses.
Description of available AC outlets.
How to adjust operating voltage.
Common problems and solutions for tuner reception.
Troubleshooting record players and tape decks.
Common problems affecting all audio sources.
Instructions for installing the amplifier in a cabinet.
Visual representations of the amplifier's circuitry.
Identifies test points for alignment procedures.
Procedure for adjusting output balance.
Procedure for adjusting current.
Lists components for ripple filters.
Lists components for speaker protection.
Lists components for minus ripple filter.
Lists components for plus ripple filter.
Lists various resistors and potentiometers.
Lists capacitors, connectors, and other parts.
Lists various switches and connectors.
Visual guide to component locations on chassis.
Overall layout of components from the top.
To Next Page
