Sansui F50 - Page 6

Unoicial Sansui F50 User Manual
Bluetooth Connection
Push the Power ON/OFF switch downward to the ON position to power on the unit.
“bLUE” will blink on the LED display screen. Search for “SANSUI F50” on your phone or
other external Bluetooth device and select to pair it once found.
FM/SW/MW Radio
Power on the unit and press the FM (SW/MW) button to enter FM (SW/MW) mode.
Turn the Tuning Knob or use the Number keys to select dierent stations. Alternatively, you
can press and hold the FM (SW/MW) button for a few seconds. The unit will then
automatically search for and store all available stations (up to a maximum of 99 stations
per band), playing the rst stored station once the process is complete.
Enter 1 or 2 digits with the numbers keys to select a stored station location. Enter 3 or 4
digits to enter a frequency. In SW mode, the radio will assume the nal two digits are to the
right of the decimal point of a frequency in MHz. For example, if you enter “1500”, the radio
will assume 15.00 MHz.
For FM and SW, extend the telescopic antenna and orient the device for best reception.
Clip on an extra length of wire to the antenna to increase the number of SW stations that
can be received.
The MW antenna is internal to the radio, along the right edge of the unit. Point the side of
the radio to the station for strongest reception. Experiment by rotating the radio to get the
strongest signal and reduce noise.
Modern home environments contain high levels of electromagnetic interference, so for
best reception, particularly on shortwave, experiment to nd locations with less noise,
including outdoor locations such as a park.