Sansui MR-6 - Page 8

Overdubbing
The
procedure
for
overdubbing
other
sections
is
the
same
as
for
basic
recording
except
that
the
recorded
tracks
are
different.
Operation
example:
To
record
keyboard
and
guitar
sound
on
Track
2
Connection
Connect the components as follows.
Level setting
(1) Press the REC SELECTOR switch of the track to be recorded onto
(i.e. TRK-2 switch). The record indicator blinks, and the DIR indica-
tor lights to indicate the track to be recorded. Ensure that the TRK-1
switch is OFF.
(2) Set the input selector for CH 1 of the MX-12 to TAPE, and that for
CH 2 to MIC/LINE.
(4) Play the musical instruments, operate the MX-12, and adjust the re-
cording level so that the readings of the level meter of both MR-6
and Mx-12 do not exceed 0 dB. (For details, please refer to the In-
struction Manual of the MX-12.)
Recording
(1) Set the PITCH control to the center position.
(2) Press the COUNTER RESET button to reset the tape counter to
0000".
(3) Press the REC button to enter the Record-pause mode.
(4) Press the PLAY button to start recording. The record indicator stop
blinking
and
lights
steadily,
indicating
that
the
recording
is
in
course.
The
sound
is
recorded
onto
Track
2
while
monitoring
the
sound
of
Track 1.
(5) After recording, press the STOP button to stop recording.
(6)
Press
the
REW
button
or
ZERO
RTN
button
to
return
the
tape
to
the
start
point.
(7)
To
prevent
accidental
erasure
of
recorded
sound,
press
the
REC
SELECTOR
switch
(TRK-2)
to
OFF.
Perform
overdubbing
on
other
tracks
(TRK-3,
TRK-4)
with
the
same
procedure
as
above.
After
each
recording,
check
the
recorded
sound
with
the
same
procedure
as
for
checking
the
basic
recording
result.
ee RR ee RNC eT EE ee Se aT SEE ee eee