Santerno DCREG4.180 User Manual

• 15P0059B3 •
DCREG2
DCREG4
USER MANUAL
28/05/18 R.07
SOFTWARE VERSION D5.02
• This manual is an integral and essential part of the product. Carefully read the instructions contained
herein as they provide important hints for use and maintenance safety.
• This device shall be used only for the purposes it is aimed at. Any other use is to be considered as
improper and dangerous. The manufacturer is not responsible for any possible damage caused by
improper, erroneous and irrational uses.
• Elettronica Santerno are responsible for the device in its original setting.
• Any changes to the structure or operating cycle of the device must be performed or authorized by
Elettronica Santerno’s Engineering Department.
• Elettronica Santerno are not responsible for the consequences resulting from the use of non-original
spare parts.
• Elettronica Santerno reserve the right to make any technical changes to this manual and the device
without prior notice. Any misprint or spelling mistake will be edited in the new versions of this manual.
• Elettronica Santerno are responsible for the information contained in the original version of the Italian
manual.
• The information contained herein is Elettronica Santerno’s property and cannot be reproduced.
Elettronica Santerno enforce their rights on the drawings and catalogues according to the law.
Elettronica Santerno S.p.A.
Via della Concia, 7 – 40023 Castel Guelfo (BO) Italy
Tel. +39 0542 489711 - Fax +39 0542 489722
santerno.com info@santerno.com
E n g l i sh

Santerno DCREG4.180 Specifications

General

Brand	Santerno
Model	DCREG4.180
Category	Media Converter
Language	English

Summary

Start-Up Procedures

Maintenance and Configuration

Control Mode Operations

Covers speed, ramp, current, and limit control modes.

Analog/Digital I/O and Parameter Management

Physical and Technical Specifications

Technical Ratings and Overload Capacity

Detailed electrical ratings, current limits, and overload capacity.

Wiring, Connections, and Components

Power Connections and Wiring Diagrams

Power wiring details for DCREG sizes and modular units.

Control Unit Terminals and Legend

Supply, Power, and Signal Terminals

Mapping and specifications for all supply, power, and signal terminals.

Power Cable Sizing and Protection

Guidelines for power cable cross-sections and protective devices.

Signal Connections and Terminal Descriptions

Signal wiring diagrams and detailed terminal descriptions.

Safety and Grounding Procedures

Proper grounding methods and safety considerations.

Control Board Indicators and Diagnostics

Keypad and User Interface

Keypad Operation Modes and Functions

LED Indicators and Local Operation

Firmware and System Architecture

Block Diagram Details

Detailed functional block diagrams of the drive's architecture.

Parameter Copy Functionality

Special Drive Features and Applications

Autotuning Procedures

Steps for automatic tuning of current, speed, and resistive drop.

Ramp Configuration for References

Motor Potentiometer and Current Limit

Digital Outputs and Adaptive Speed

Parameter Reference Guide

Measure Parameters (Mxxx)

Programming Parameters (Pxxx)

Parameters for configuring drive operation and settings.

Configuration Parameters (Cxxx)

Parameters for setting drive behavior, I/O, and alarms.

Diagnostics and Troubleshooting

Alarm Parameters and Codes

Detailed list of alarms, their causes, and handling procedures.

Warning Parameters and Codes

EMC Characteristics and Input Filters