Santerno SINUS VEGA 2S User Manual (English)

Questions and Answers:

B
benjaminlopezSep 6, 2025
Why is the inverter module heatsink overheating in my Santerno SINUS VEGA 2S Inverter?
- J
  jgarciaSep 6, 2025
  If your Santerno Inverter's module heatsink is overheating, it could be due to several factors. The ambient temperature might be too high, so lower the ambient temperature. There could be an obstruction in the ventilation channel, so clear the ventilation channel. The fan may not be working, so replace the fan. In some cases, it could be due to an inverter fault, so seek service.
S
schmidtjenniferSep 8, 2025
What causes unexpected stops during running of Santerno SINUS VEGA 2S?
- J
  Julia KelleySep 8, 2025
  If you are experiencing unexpected stops during running with your Santerno Inverter, it could be due to several reasons: * An alarm may have occurred, so find out the reason and reset. * A single cycle of PLC may have finished, so check PLC configuration. * There may be an interruption of the communication between the inverter and host or flush mount faceplate, so check communication cables and FB.02, FB.03 settings. * There may be a power failure, so check the power supply. * The command input method may have changed, so check the command input method and corresponding parameter. * The positive/negative logic of control terminal may have changed, so check F9.15.
I
Ian BuckSep 9, 2025
What to do if Santerno SINUS VEGA 2S shows emergency stop or external equipment fails?
- D
  Dawn CaseySep 9, 2025
  If your Santerno Inverter experiences an emergency stop or external equipment fails, it could be due to several reasons. If you press the STOP key when operating in non-keypad mode, check the present operating mode. Pressing STOP when the inverter is in stall status can cause this, so set the operating parameters correctly. The inverter will report an F.Ed fault if it is in stall status for 1 minute, so set the operating parameters correctly. If the terminal used for stopping the inverter in an emergency is closed, disconnect the terminal if the external fault is cleared.