Sanus VMT5 - Page 11

11
11
10
Cover
Cover
11
10. Install the bottom two lag bolts
13
. Tighten all four lag bolts
13
only until they are pulled firmly against the wall plate
11
.
NOTE: Hold the wall plate
11
in place when tightening the first lag bolt
13
to keep the plate from shifting out of place.
CAUTION: Improper use could reduce the holding power of the lag bolt
13
. DO NOT over-tighten the lag bolts.
11. Slide the covers closed on wall plate
11
.
Go to STEP 3 on PAGE 21.
13
11