10
Operator
Fault diagnostics
Error diagnostics and bug fixing to be performed only in de-
energised state.
Operator
The first step in troubleshooting is to observe the indicator ele-
ments in the cabin. The light in the right-hand operating area
indicates a fault without providing exact information about the
cause. The operator must stop operation and determine the
cause of the error. Further information is available on the dis-
play.
If the machine exhibits error functions or poor performance, the
operator must also immediately stop operation and determine
the cause of the error.
The software offers a wide range of troubleshooting possibilities.
The start screen graphically represents all error messages. The
operator can access more information by selecting the corres-
ponding function unit using the function keys.
The operator has the possibility to remedy errors that are
described in the operating manual in the Troubleshooting chap-
ter. Any other errors must be fixed by maintenance or service
personnel.
Maintenance personnel
The maintenance technician has further troubleshooting options
available. By entering a password, the maintenance technician
can use the software to receive additional information.
The technical documents from the supplier are also available.
These include troubleshooting information for the engine, gear-
box, hydraulic system and attachment.
Errors extending beyond that may only be resolved by SANY
service personnel or by the component manufacturers.
Supposed errors
The events described below are not disturbances but intentional
deviations.
Information concerning additional limitations of machine perfor-
mance can be found in the option list in the Annex of the Opera-
ting Manual.
▪ The engine does not start because the parking brake was
not applied before the machine was switched off. The par-
king brake must first be activated, and then deactivated
again.
▪ The machine's travelling speed is restricted. Speed can also
be further limited as an option, upon the operator's request.
To Next Page
Loading...