EasyManuals Logo

Sanyo ASW U1100T User Manual

Sanyo ASW U1100T
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
-
10
-
9. Indication and judgment of troubles
Trouble judgment
:
During operating, when trouble occurs, microchip will judge the cause and stop the present operation. Water
level indicator blinks on and off and buzzer sounds.
Troubles
Judgment
Check
Abnormal
condition
of spinning
The Safety Switch works 3 times
continuously during Spin cycle.
Spin Tub is in unbalance, the laundry leant to
one side.
Abnormal condition
of draining
During draining, the water level doesn t
go down below the reset point within 8
minutes.
The Drain Hose hasn t been put down from the
washing machine.
Drain Hose is dented.
The Drain Hose is clogged.
Abnormal condition
of water supply
During supplying water, water level
does not reach to LOW 1 level within 15
minutes.
The faucet isn
t turned on.
Water pressure is very low.
Water source is cut off.
Water supply valve is clogged.
Abnormal condition
of water level
sensor
The frequency of water level sensor is
higher than 73.728 KHz or lower than
8.192 KHz.
Water level sensor is defecti
ve.
Connector is poorly connected.
Abnormal condition
of the load sensor
During rotating of pulsator, the pulse
which is counted by motor is low than 2.
Motor rotated badly.
Tension strength of V
-
Belt is out of
specification.
Abnormal information
:
Buzzer sounds with 0.3 seconds ON
-
0.3 seconds OFF cycles in 16 times.
Depending on the kind of troubles, the indicators will blink on as bellow:
The blinking of indicators
Kind of Trouble
Spinning
Drain
Water supply
Washing
(Child safety mode)
Other troubles
Trouble release
:
Trouble
Indication
Where to check
Close the Washer Lid.
Check whether the laundry is clumped on one side of the Wash/ Spin Tub or not.
Check whether the Washer is on
the level surface or not.
Check whether the
Child safety mode
is set or not. Close the Washer Lid.
Turn the water supply faucet on.
Check whether the water supply has been cut off or not.
Check whether the metal filter of the Water Inlet
is clogged or not.
Check whether the washer has been freezing or not.
Put down the Drain Hose from the hookhole.
Check whether there is anything wrong with the Drain Hose or not.
Check the Drain Hose for any obstructions.
Check whether the Drain Hose is
clogged with lint or not.
Check whether the Drain Hose rises too high (more than 15 cm) off the ground or not.
Check whether the Drain Hose is too long (longer than 3m) or not.
Check whether the diameter of the Drain Hose is too small or not.
Press the
START/ PAUSE button or turn the POWER SWITCH.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo ASW U1100T and is the answer not in the manual?

Sanyo ASW U1100T Specifications

General IconGeneral
BrandSanyo
ModelASW U1100T
CategoryWasher
LanguageEnglish

Related product manuals