- 7 -
After water level reaches reset point, draining course continues
for 1 40 .
Before completion of spinning, electrical continuity of motor
breaks off and motor r
otates continuously by inertia. The Brake
Ass y activates while Spin Tub revolution speed is slowing down.
During Spinning: If the clothes clump on one side and/ or the
Wash/ Spin Tub becomes unbalanced, the microchip will detect
the unbalance condition an
d automatically proceed the following
corrective.
Same as the operation of the Rinsing course, Spin Tub Drum will
rotate intermittently. However, while selecting the soft spin
function, the operation of spinning course is different.
BLANKET
Course:
Turn
on the power switch (ON/ OFF).
Load the laundry into the washer.
Press the ONE TOUCH SELECT to select the BLANKET course for big size laundry.
Press the START/ PAUSE button
Water is supplied to HIGH water level.
Depending on the size of laundry,
for best results, use MED
water level
Pulsator will rotate and select the suitable water flow.
After water level reaches reset point, Draining course continues
for 1 40 .
Water is supplied to the selected water level.
Intermittent spin cycle:
1 10 ON.
Continuous spin cycle: 2 20 ON.
During spinning, if unbalance condition occurs, safety switch will
activate.
Water is supplied to HIGH level.
Overflow rinse: Twice overflow
After water level reaches reset point, Draining course continu
es
for 1 40 .
Intermittent spin cycle: 1 10 ON.
Continuous spin cycle: 2 20 ON.
During spinning, if unbalance condition occurs, safety switch will
activate.
Special usage:
Press the WATER LEVEL button before pressing
START/ PAUSE button.
The washer will
operate with manual
set water level.
Pressing the START/ PAUSE button while there have
been water in Spin Tub Drum.
Water level in the Spin Tub Drum is lower than
LOW1 level.
Water level in the Spin Tub Drum is higher than
LOW1 level.
The washer wil
l operate normally
The washer will operate with:
Water level: HIGH
To Next Page
Loading...
Need help?
General
