EasyManua.ls Logo

Sanyo CM29FS2 - Page 12

Sanyo CM29FS2
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Menu Operation
3
3 You can either...
a) Enter the frequency using the 0-9 buttons
referring channel table.
b) Press and hold or button until
frequency starts scanning (about 5 seconds),
scanning will stop when a channel is found.
When the picture is not clear, change the colour
system.
To change the colour system;
Select SYSTEM” with or , and select a
correct colour system with or
.
When the sound is not clear or no sound is
produced, change the sound system.
To change the sound system;
Select SIF” with or , and select a
correct sound system with or
.
4
4 Select “MEMORY” and press or to store
your preferred channel.
5
5 Press the MENU button repeatedly to exit.
Repeat above for other programme position if
required.
Note:
AFC (Automatic Frequency Control) of PRESET
menu is usually set “ON”. It will automatically fine
tune.
2
2 Select “FREQUENCY”.
PRESET
FREQUENCY
SYSTEM
POSITION
AUTO TUNING
SIF
AFC
7
AUTO
271.65 MHz
BG
ON
SKIP
OFF
MEMORY
- -
PRESET
FREQUENCY
SYSTEM
POSITION
AUTO TUNING
SIF
AFC
7
AUTO
6 - - . - - MHz
BG
ON
SKIP
OFF
MEMORY
- -
PRESET
FREQUENCY
SYSTEM
POSITION
AUTO TUNING
SIF
AFC
7
AUTO
677.25 MHz
BG
ON
SKIP
OFF
MEMORY
OK!
c) Fine Tuning
Press and release or repeatedly to
re-tune the frequency.
12
12
Manual Tuning
1
1 Select “POSITION” from the PRESET menu.
And select programme position where you wish
to preset a channel using the “0-9”, -/--,
or buttons
.
PRESET
FREQUENCY
SYSTEM
POSITION
AUTO TUNING
SIF
AFC
7
AUTO
271.65 MHz
BG
ON
SKIP
OFF
MEMORY
- -
1
1 Press the MENU button, then select
“PRESET” menu with
.
2
2 Press or to display “PRESET” menu,
and “AUTO TUNING” will be selected first.
Automatic Tuning
PRESET
FREQUENCY
SYSTEM
POSITION
AUTO TUNING
SIF
AFC
1
AUTO
271.65 MHz
BG
ON
SKIP
OFF
MEMORY
- -
Automatic tuning can be cancelled at any time by
pressing the MENU button.
3
3 Press or to start Automatic tuning.
After completing Auto tuning, the TV set
automatically returns to programme position
“1”.
4
4 Press the MENU button repeatedly to exit.
Inst. Manual C8ZRL-A (ME) 12/7/05 3:48 PM Page 12

Other manuals for Sanyo CM29FS2

Related product manuals