Sanyo CVW-EXA284 - Installing Patch Ends

13
3.8 Installing Patch Ends
1. Apply gasket to case body (per previous instructions).
2. If present, remove protective film from inside wall of Patch
End.
3. Place Patch End to line up with bolt holes.
4. From inside unit ratchet in M8 & optional M5 bolt into Patch
End until secure.
5. Apply Silicone sealant between inside of Patch End and lower
frame (see drawing to the left for details).
6. Attach side cover (item 3 in above drawing)
① Gasket
② M8 Bolts
③ Side Cover
④ Suction Lamp Cover Joint
⑤
M5 Bolts
Apply silicone sealant inside
after installing the patch end.
CVW-EXA284/224
CVW-EXA184/124