Note:
Do not connect the mains lead to an AC outlet until all connections
have been made.
The system is not disconnected from the mains unless the mains lead
is unplugged from the AC outlet.
Speakers
When connecting the speakers, make sure that (+) and (-) polarities are
matched properly. Otherwise, the sound may appear to be lacking in the
bass range and in stability.
Connect the speaker wire with the stripe to the red terminal (+) and the
other wire to the black terminal (-).
FM aerial
The FM indoor aerial is sufficient to receive most local FM broadcasts and
should be connected to the EXT. ANT. terminal. Extend the aerial wire as
straight as possible and, while listening to the sound from the system,
secure it in a position which yields minimal distortion and noise.
In fringe areas or where reception is distorted or noisy, an FM outdoor
aerial (not supplied) should be connected instead of the indoor aerial.
The terminals will accept 75-ohm coaxial cable. Consult your dealer.
AM loop aerial
Assemble the loop aerial as shown in figure,
Unwind the aerial wires (about 2 turns), then connect them to the AM
LOOP ANT. terminals. Place the loop aerial in a position which yields the
best AM reception, or attach it to awallorother surface as shown in figure.
C5
not supplied)
Note:
To minimize noise, the speaker, mains and any other leads should not
come close to the FM indoor oroutdooraerial lead and AM Ioopaerial. Do
not place the aerial leads close to the system.
Turntable
Connect the output leads and earth lead of a turntable (MM type) to the
PHONO sockets and GND terminal of the unit respectively.
Headphones
Connect stereo headphones (not supplied) to the PHONES socket for
monitoring or forprivate listen ing. Thespeakers areautomatically discon-
netted when headphones are connected.
-2-
To Next Page
Loading...
