- 7 -
SERVICE MODE
Region Setting
Internal Setup
Market 00
Region 1
Exit
00-WM 01-SFC 02-CA 03-EUR 04-EUS
05-EUC 06-DER 07-DES 08-DEC 09-AU
10-SS 11-PA 12-NTX 13-CN 14-JP
1
Internal Setup
Market 00
Region 1
00-WM 01-SFC 02-CA 03-EUR 04-EUS
05-EUC 06-DER 07-DES 08-DEC 09-AU
10-SS 11-PA 12-NTX 13-CN 14-JP
Exit
Save of Setting Data
Region 1 Market
WM
Back end Version
S
40726
A6
Loader Version 03.01.20.28
SettingVersion of
display
Vaddis6
4. Setting REGION code
4.1 While a highlighted indicator is displayed on the right
side of the Region denotation, push ENT, and each
button on the remote controller. With each push the
indicator will advance as shown below.
1 <-> 2 <-> 3 <-> 4 <-> 5 <-> 6
4.2 Set up the region coder currently displayed on the set.
4.3 Once the desired number is displayed, push
button to
move the highlighted indicator to Exit area.
5. Saving settings
5.1 Make sure that the Market and Region settings are
properly set.
(If any of the settings are incorrect, you can make a
change by moving the indicator using
button, and
following procedures 3 and 4 above. )
5.2 After ensuring that the settings are all correct, push
ENT button while the indicator is on Exit area.
The settings are now saved.
6. Finishing settings
6.1 After a few seconds, the Internal Setup screen
disappears, and then the Service Mode screen is
displayed again for three seconds as shown on the right.
You should check the settings.
6.2 Power OFF.
Backendversion
S
40726 A 6
Brand (S : SANYO , F : FISHER)
Version ( 2 0 0 4. 7. 26 )
Sub Version (A,B,......Z)
Region ( 0 : Region undefined
1 ~ 6 : Region defined )
The region coder of this model is 2.
4.2 Set up the region coder currently displayed on the set.4.2 Set up the region coder currently displayed on the set.
To Next Page
Loading...
