Need help?Do you have a question about the Sanyo DC-C10 and is the answer not in the manual?
General| Brand | Sanyo |
|---|---|
| Model | DC-C10 |
| Category | Stereo System |
| Language | English |
Reception frequency, MW, LW.
Type, channels, sampling frequency, pick-up, frequency response, wow and flutter.
Power requirements, dimensions, weight.
Type, drivers, maximum power-handling, nominal impedance, dimensions, weight.
Cable connection and tracking balance, eye pattern checks.
Procedures for replacing tape heads and adjusting azimuth.
Motor speed adjustment and mechanism torque measurements.
Location of tuner components and FM, MW, LW adjustment steps.
List of included accessories and packaging materials.
List of parts for the main unit's casing and chassis.
List of screws, springs, and other fasteners used in assembly.
List of electronic components like transformers, fuses, ICs, and transistors.
Parts list for the printed circuit board controlling the tape deck.
Parts list for the front panel control board.
Parts list for the amplifier and tuner circuitry board.
List of electronic components like capacitors, ICs, and transistors.
Parts list for the CD player's printed circuit board.
Parts list for the primary and secondary power transformer boards.
Detailed parts list for the tape mechanism.
Detailed parts list for the CD changer mechanism.
Detailed parts list for the CD base mechanism.
Pin functions and block diagram for the servo processor IC.
Pin functions and block diagram for the digital signal processor IC.
Pin functions and block diagram for the pickup actuator and motor control IC.
Block diagram and function of bridge driver ICs.
Block diagram and function of AM/FM IF amplifier IC.
Block diagram and function of PLL synthesizer IC.
Block diagram and function of audio control IC.
Block diagram and function of voltage regulator IC.
Pin functions and block diagram for the micro processor IC.
Voltage measurements for IC101 during PLAY and STOP modes.
Voltage measurements for IC102 during PLAY and STOP modes.
Voltage measurements for IC103 during PLAY and STOP modes.
Voltage measurements for IC131 during different modes.
Voltage measurements for IC132 during different modes.
Voltage measurements for IC601 during PLAY and STOP modes.
Voltage measurements for various transistors (Q1301, Q1401, Q6001, etc.).
Wiring diagram for the CD changer mechanism.
Wiring diagram for the tape deck's printed circuit board.
Wiring diagram for the amplifier and tuner board.
Wiring diagram for the front panel board.
Step-by-step instruction to remove the CD changer cover.
Procedure to partially disassemble the CD drawer.
Procedure to fully disassemble the CD drawer.
How to check and confirm carriage position.
Procedure to re-seat a dislodged carriage.
Procedure to correct incorrect carriage positioning.
Step-by-step guide for reassembling the CD mechanism.
Steps to check unit operation after power on and identify initial faults.
Troubleshooting carriage movement and drive problems.
Troubleshooting issues with the CD drawer not moving or completing initial operation.
To Next Page
