Sanyo DC-C10 - 3 CD MECHANISM INSTRUCTION - Mechanism Assembly; G. Mechanism Assembly

- 7 -
G.Mechanism Assembly (Fig.10)
1. Make sure CM18 BEVEL GEAR 4 is in the place.
2. Make sure CM39 GEAR IDLER A2 is in the place.
3. Match CM27 BEVEL GEAR 1 as shown in the illustration (Fig.11).
4. Assemble the right side of CM02 DRAWER 2.
5. Insert Section A and slid it toward front as shown int the illustration (Fig.12).
6. Push it into CM01 ASSY CHASSIS.
7. Push CM02 DRAWER 2 back into the position.
8. Assemble CM23 COVER 2.
Fig,10
Fig.12
Fig.11
3
ARM STOPPER B
CM38
2
3
4
1
3
A
A
B
GEAR IDLER A2
CM39
B
CHASSIS
CM01
DRAWER 2
CM2
BEVEL GEAR 4
CM18
BEVEL GEAR 1
CM27
3 CD MECHANISM INSTRUCTION