Sanyo DC-C10 - 3 CD MECHANISM INSTRUCTION - Carriage Handling; D. Position confirmation; E. Carriage Re-seating Procedure

- 4 -
D. Position confirmation
1. Rotate CM18 BEVEL GEAR 4 to check CM12/CM13 (or CM14) CARRIAGE movement and position.
If it is good, two carriages are the same position at the end (front position) (Fig.3).
E. If CARRIAGE was slid out of the drawer,
1. Turn CM18 BEVEL GEAR 4 to rotate CM19 CARRIAGE LIFT until it stops once (Fig.4).
2. Place CM13 CARRIAGE No.2 as shown in the illustration (Fig.5).
3. Turn CM18 BEVEL GEAR 4 to slide the carriage into its position.
Keep rotate until it sopts.
1
2
2
1
NO.1 CARRIAGE
CM12
NO.2 CARRIAGE
CM13
BEVEL GEAR 4
CM18
1
2
3
4
1st. TOOTH
AB
C
D
NO.2 CARRIAGE
CM13
Fig.3
Fig.5
CARRIAGE LI
F
CM19
NO.1 CARRIAGE
CM12
NO.2 CARRIAGE
CM13
BEVEL GEAR 4
CM18
Fig.4
3 CD MECHANISM INSTRUCTION