Sanyo DP32242 - EDITING AND SETTING CHANNELS; ANTENNA;CABLE SETUP AND AUTO PROGRAM; MANUAL PROGRAM SETTINGS

22
English
EDITING AND SETTING
CHANNELS
The current channel settings can be changed according
to your needs and reception conditions.
ANT/CABLE SETUP AND OPERATION
1
Press MENU button on the remote control and use
the CURSOR ŻDQGŹ buttons to select SETUP
menu. Press the OK button.
2
Use CURSOR ŸDQGź buttons to highlight ANT/
Cable setup function. Press the OK button.
Auto program (Set automatically)
Automatically searches and adds available channels to
the memory.
1
Use CURSOR ŻDQGŹ buttons to select (Cable /
Antenna / Not used). Press the OK button.
2
Use CURSOR ŸDQGź buttons to select Auto
Program mode. Press the OK button.
3
Use CURSOR ŸDQGź buttons to select scanning
mode function. Press the OK button.
Note:

After the scanning is completed, select Apply.

All previously saved channels are erased.
Manual program
Add or remove channels from memory, edit channel
caption and set favorite channels
.
1
Use CURSOR ŸDQGź buttons to select Manual
Program mode. Press the OK button.
2
Press Edit item. Use CURSOR ŻDQGŹ buttons to
select the setting you want to adjust and press the
OK button.
3
Use CURSOR ŻDQGŹ buttons to select the item to
edit (Caption / Favorite / Add). Press the OK button.