Sanyo DS13204 User Manual

AS
FILE NO.
SERVICE MANUAL
(SUPPLEMENT)
Remote Control Color
Television
DS13204 (U.S.A.)
(CANADA)
ORIG1NAL VERSION
Chassis No. 13204-00
NOTE: Match the Chassis No. on
the unit’s back cover with
the Chassis No. in the
Service Manual.
If the Original Version
Service Manual Chassis
No. does not match the
unit’s, additional Service
Literature is required. You
must refer to “Notices” to
the Original Service Manual
prior to servicing the unit.
G8PEM, PRODUCT CODE 111371984
REFERENCE No. SS780045
THIS CHASSIS IS SIMILAR TO MODEL DS13330, CHASSIS NUMBER
13330-01. SERVICE INFORMATION GIVEN IN THIS MANUAL IS ONLY THE
DIFFERENCE INFORMATION FROM MODEL DS13330, CHASSIS
NUMBER 13330-01. FOR ADDITIONAL SERVICE INFORMATION, REFER
TO THE SERVICE MANUAL FOR CHASSIS NUMBER 13330-01 USED IN
MODEL DS13330 (SM780087).
AS
POWER
MENU
CH
VO
L
AUDIO IN
VID
EO
IN

Sanyo DS13204 Specifications

General

Brand	Sanyo
Model	DS13204
Category	TV
Language	English

Summary

Specifications

Safety Instructions

General Safety Precautions

Essential safety measures for servicing, including antenna and leakage checks.

X-Radiation Precaution

Measures to prevent excessive X-ray emission from the picture tube during servicing.

Product Safety Notice

Important notice regarding replacement parts and overall product safety.

Service Adjustments

Service Menu Operation and Setup

How to enter, use, and perform initial data setup for the on-screen service menu.

Picture Adjustments

Procedures for adjusting picture centering, size, grayscale, and focus.

Signal and Voltage Adjustments

Adjustments for VCO, RF AGC, brightness, and voltage checks.

Audio/Video and Special Tests

Adjustments for video/sound levels and specific tests like HV hold-down.

Drive and Bias Adjustments

Red/Blue Drive Adjustments

Procedure for adjusting the red and blue drive levels using the service menu.

Red/Green/Blue Bias Adjustments

Procedure for adjusting bias levels for red, green, and blue color signals.

Program Code

Service Hints

Power Failure Detector

Purity and Convergence Adjustments

Purity Adjustments

Procedures for adjusting the picture purity after component replacement.

Center Convergence Adjustment

Steps to adjust picture convergence in the center area of the screen.

Outer Area Convergence Adjustment

Steps to adjust picture convergence in the outer areas of the screen.

Component and Test Point Locations

Schematic Diagrams

Waveforms

Voltage Charts