7
USING THE MULTIMEDIA REMOTE CONTROL
REMOTE CONTROL KEYS
➀
Mode Keys—Use these keys to program the
remote control and to select the operating mode
(VCR, TV, CABLE, DVD, SAT, or AUX). To
Operate Your... VCR—Press the VCR key;
Television—Press the TV key; Cable Box—Press
the CABLE key; DVD Player—Press the DVD key;
and Satellite Receiver—Press the
SAT
key.
Note: Make sure you hold
down the mode key
while entering a code number, see page 9.
➁
Input Key—In the TV and Satellite modes, this
key selects the program source to display on the
screen (TV signal or signal from equipment con-
nected to the AV jacks). In the VCR mode, this key
functions as a VCR’s TV/VCR key.
➂
Number Keys—Two keys must be pressed to select
a channel. Example: Press 0 then 6 to select channel
6. For cable channels 100 through 125
, press and
hold the 1 key until C1–– appears. Then press the
other two numbers.
➃
Caption Key—See page 17.
Operates your TV, VCR, DVD, Cable converter box, and Satellite Receiver. To program
the remote control, see pages 9 ~ 11.
INSTALL BATTERIES AS SHOWN (2 AA, not included)
Notes:
– Do not mix old batteries with new ones or mix different types of
batteries together.
– Remove the batteries if the remote control will not be used for a
month or more. Weak batteries may leak and cause damage.
(Normal battery life is roughly six months.)
IMPORTANT NOTE: Spent or discharged batteries must be recycled or disposed
of properly in compliance with all applicable laws. For detailed information,
contact your local County Solid Waste Authority.
QuickTips
■
Be sure batteries are
installed correctly.
■
Point the remote
control toward the
equipment you want to
operate. Objects bet-
ween the remote
control and the equip-
ment may cause
misoperation of the
remote control
function.
■
If the remote control
does not work: Press
TV key (see item 1).
■
The remote control
must be programmed
before it will operate
your VCR, DVD
Player, Satellite
Receiver, or Cable
Box. See pages 9~11.
Note: Sanyo’s VCR
and DVD codes are
preprogrammed.
■
Cannot select
channel with number
keys. Press “0”in
front of numbers 1~9.
Example: Channel 05.
■
Adjusting the volume
level: Flashing Right
arrow indicates
volume is increasing
and flashing Left
arrow indicates
volume is decreasing.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
To Next Page
Loading...
Need help?
General
